815-TS12A4517D

Manufacturer:

Texas Instruments

Product Number:

815-TS12A4517D

Description:

TS12A4517D Overview

Packed in 8-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. To ensure high reliability, a new packaging method Tube is used.

Datasheet:

-

Description:

TS12A4517D Overview

Packed in 8-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. To ensure high reliability, a new packaging method Tube is used. There is an analog multiplexer mounted in position Surface Mount. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Extended operating temperature around -40°C~85°C TA. The total number of terminations is 8. The electronic part provides high-quality output because it has 1 channels. When the electronic component is given a voltage of 1.8V, it should be turned on and run. As part of the design of the 8 series, this electronic part has been incorporated into the system. Based on SPST - NC switching circuits, these analog multiplexers work. Try searching for the analog switch ic with TS12A4517 if you are looking for variants. This digital multiplexer has 20Ohm internal resistance. Datasheets for functions of 8 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 6V volts for the multiplexer. A analog switch ic that has a cost-effective Dual supply type. It is recommended that the electrical component receives a voltage of 1V. An operating current of 70μA would be sufficient for this switch device. A voltage higher than 70μA may cause damage to the switch multiplexer. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 1V. This analog switch ic utilizes SEPARATE OUTPUT output. There are 1 inputs to be operated. There are 464MHz bandwidths for data transfer. Don't forget the additional features of this electronic part, such as: SUPPLY VOLTAGE CAN ALSO OPERATE WITH 3V TO 3.6V.

TS12A4517D Features

1 Channels
Switch Circuit: SPST - NC
70μA Supply Current
Bandwidth: 464MHz
Additional Features: SUPPLY VOLTAGE CAN ALSO OPERATE WITH 3V TO 3.6V

TS12A4517D Applications

There are a lot of Texas Instruments TS12A4517D Analog Switches & Multiplexers ICs applications.

• Digital access cross connects
• E1 Network Equipment
• HDTV
• CSU
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Communication systems
• Precision test equipment
• PBXs
• SDH
• Audio signal routing