My Cart
Total:0Sub-Total : $0.00
CD74HC4066E CD74HC4066E

815-CD74HC4066E

Manufacturer:

Ultralife

Product Number:

815-CD74HC4066E

Description:

CD74HC4066E Overview


Presented in 14-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. Advanced packaging method Tube is used to provide high reliability

Datasheet:

-

Description:

CD74HC4066E Overview


Presented in 14-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. Advanced packaging method Tube is used to provide high reliability. Through Hole is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -55°C~125°C TA. Totally, there are 14 terminations. As a result of its 4 channels, this electronic component provides high-quality output. A 4.5V voltage supply should turn on and run the electronic component. An electrical component like this is included in the 14 series. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching for 74HC4066 variants of the analog switch ic. Internally, this switch multiplexer has a resistance of 70Ohm. Please refer to the datasheets for 14 pins functions. The analog multiplexer shown here is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 10V. Analogue multiplexers of the Single supply type that are cost-effective. 2V is the lowest voltage that should be fed to the electronic electronic part. A voltage of 2V~10V is required to drain this analog switch from a single voltage supply. Put voltage above 16μA on the multiplexer to cause damage. 200MHz bandwidths enable data to be transferred.

CD74HC4066E Features


4 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz

CD74HC4066E Applications


There are a lot of Texas Instruments CD74HC4066E Analog Switches & Multiplexers ICs applications.

  • Microprocessor controlled systems
  • Residential Gateways, Home Gateway/Router
  • Data Acquisition Systems
  • Channel Banks
  • Mechanical reed relay replacement
  • Industrial and process control systems
  • Intelligent PBX
  • Multiplexers
  • Precision instrumentation
  • Battery Powered Instruments


Quantity:

Payment Methods:

Delivery Services:

In Stock

Please send RFQ , we will respond immediately.

certificate certificate certificate certificate certificate
CD74HC4066E information

Specifications
ACL Staticide Inc CD74HC4066E technical specifications, attributes, parameters and parts with similar specifications to ACL Staticide Inc CD74HC4066E
  • Type
    Parameter
  • Factory Lead Time
    6 Weeks
  • Lifecycle Status
    ACTIVE (Last Updated: 2 days ago)
  • Contact Plating
    Gold
  • Mount
    Through Hole
  • Mounting Type
    Through Hole
  • Package / Case
    14-DIP (0.300, 7.62mm)
  • Number of Pins
    14
  • Weight
    927.99329mg
  • Operating Temperature
    -55°C~125°C TA
  • Packaging
    Tube
  • JESD-609 Code
    e4
  • Part Status
    Active
  • Moisture Sensitivity Level (MSL)
    1 (Unlimited)
  • Number of Terminations
    14
  • ECCN Code
    EAR99
  • Resistance
    70Ohm
  • Subcategory
    Multiplexer or Switches
  • Technology
    CMOS
  • Terminal Position
    DUAL
  • Number of Functions
    4
  • Supply Voltage
    4.5V
  • Base Part Number
    74HC4066
  • Pin Count
    14
  • Polarity
    Non-Inverting
  • Number of Channels
    4
  • Max Supply Voltage
    10V
  • Min Supply Voltage
    2V
  • Max Supply Current
    16μA
  • Throw Configuration
    SPST
  • Turn On Delay Time
    15 ns
  • Input Voltage (Min)
    2V
  • Supply Type
    Single
  • Bandwidth
    200MHz
  • Rise Time
    400ns
  • Turn-Off Delay Time
    30 ns
  • On-State Resistance (Max)
    70Ohm
  • High Level Output Current
    25mA
  • Low Level Output Current
    25mA
  • Multiplexer/Demultiplexer Circuit
    1:1
  • Off-state Isolation-Nom
    72 dB
  • Current - Leakage (IS(off)) (Max)
    100nA
  • Channel Capacitance (CS(off), CD(off))
    5pF
  • On-state Resistance Match-Nom
    1Ohm
  • Switch Circuit
    SPST - NO
  • Channel-to-Channel Matching (ΔRon)
    500m Ω
  • Crosstalk
    -72dB @ 1MHz
  • Switching
    MAKE-BEFORE-BREAK
  • Voltage - Supply, Single (V+)
    2V~10V
  • Normal Position
    NO
  • Height
    5.08mm
  • Length
    19.3mm
  • Width
    6.35mm
  • Thickness
    3.9mm
  • Radiation Hardening
    No
  • REACH SVHC
    No SVHC
  • RoHS Status
    ROHS3 Compliant
  • Lead Free
    Lead Free
CD74HC4066E Relevant information

Hot Sale
Related Mode
The following parts include "CD74HC4066E" in ACL Staticide Inc CD74HC4066E.
  • Part Number
  • Manufacturer
  • Package
  • Description
Purchase and inquiry

Purchase & Inquiry
Transport
Purchase

You may place an order without registering to ShineEver.
We strongly suggest you sign in before purchasing as you can track your order in real time.

Means of Payment

For your convenience, we accept multiple payment methods in USD, including PayPal, Credit Card, and wire transfer.

RFQ (Request for Quotations)

It is recommended to request for quotations to get the latest prices and inventories about the part.
Our sales will reply to your request by email within 24 hours.

IMPORTANT NOTICE

1. You'll receive an order information email in your inbox. (Please remember to check the spam folder if you didn't hear from us).
2. Since inventories and prices may fluctuate to some extent, the sales manager is going to reconfirm the order and let you know if there are any updates.

Shipping Cost

Shipping starts at $40, but some countries will exceed $40. For example (South Africa, Brazil, India, Pakistan, Israel, etc.)
The basic freight (for package ≤0.5kg or corresponding volume) depends on the time zone and country.

Shipping Method

Currently, our products are shipped through DHL, FedEx, SF, and UPS.

Delivery Time

Once the goods are shipped, estimated delivery time depends on the shipping methods you chose:

FedEx International, 5-7 business days.

The following are some common countries' logistic time.