815-SN74HC574DBR

Manufacturer:

Ultralife

Product Number:

815-SN74HC574DBR

Description:

SN74HC574DBR Overview

The flip flop is packaged in a case of 20-SSOP (0.209, 5.30mm Width). D flip flop is embedded in the Tape & Reel (TR) package. As configured, the output uses Tri

Datasheet:

-

Description:

SN74HC574DBR Overview

The flip flop is packaged in a case of 20-SSOP (0.209, 5.30mm Width). D flip flop is embedded in the Tape & Reel (TR) package. As configured, the output uses Tri-State, Non-Inverted. Positive Edgeis the trigger it is configured with. There is an electrical part that is mounted in the way of Surface Mount. The supply voltage is set to 2V~6V. It is at -40°C~85°C TAdegrees Celsius that the system is operating. This D latch has the type D-Type. This type of FPGA is a part of the 74HC series. A frequency of 40MHzshould be the maximum output frequency. The element count is 1 . A total of 20 terminations have been made. The object belongs to the 74HC574 family. Power is supplied from a voltage of 5V volts. Input capacitance of this device is 3pF farads. A device of this type belongs to the family of HC/UH. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. There is a clock edge trigger type of Positive Edgeon this device. This part is included in FF/Latches. The design is based on 8bits. There is a 6Vmaximum supply voltage (Vsup). It is imperative that the supply voltage (Vsup) is maintained above 2Vin order to ensure normal operation. Due to its superior flexibility, it uses 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. The D latch runs on a voltage of 2/6V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. Optimal efficiency requires a supply voltage of 5V. It offers maximum design flexibility with its output current of 7.8mA. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. There is a consumption of 8μAof quiescent current from it.

SN74HC574DBR Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC574DBR Applications

There are a lot of Texas Instruments SN74HC574DBR Flip Flops applications.

• Event Detectors
• Registers
• Bus hold
• Synchronous counter
• Modulo – n – counter
• Counters
• Circuit Design
• Single Up Count-Control Line
• Buffered Clock
• Shift Registers